BETCO PB24-11 Instrukcja Operatora Pobierz pdf (Strona 12)

TIGHT.

TILT MACHINE ON SIDE. •

HONDA MACHINE MUST BE TILTED TO •

THE RIGHT, AS VIEWED FROM THE REAR.

DO NOT TILT AIR FILTER DOWN. RIGHT IS

RIGHT.

DOES NOT MATTER WHICH SIDE TO TILT •

KAWASAKI, SINCE AIR FILTER IS IN THE

FRONT.

REMOVE PAD CENTERING DEVICE.•

REPLACE PAD. BE SURE IT IS CENTERED WELL.•

REPLACE PAD CENTERING DEVICE. SCREW •

VIEWED FROM FRONT

TILT THE MACHINE BACK ON CASTER.•

REMOVE PAD CENTERING DEVICE BY •

UNSCREWING.

REMOVE OLD PAD.•

REPLACE WITH NEW PAD OF CORRECT •

SIZE. BE SURE PAD IS CENTERED.

REPLACE PAD CENTERING DEVICE •

AND FULLY TIGHTEN.

SPIN PAD DRIVER THIS

DIRECTION TO REMOVE

•

NEED TO LAY ON FLOOR TO GET THREADS STARTED.

•

SPIN PAD DRIVER ON SHAFT (CLOCKWISE AS VIEWED FROM BOTTOM). MAY

TILT MACHINE BACK•

PLACE 3/4" OPEN END WRENCH ON FLATS ON TOP OF SHAFT•

SPIN PAD DRIVER IN DIRECTION SHOWN TO REMOVE (COUNTER-CLOCKWISE •

AS VIEWED FROM BOTTOM)

REPLACE PAD AS DESCRIBED ABOVE

SEE DETAIL

THERE ARE THREE WAYS TO CHANGE THE PAD

AIR FILTER MUST BE TILTED UP.

DO NOT

TILT

AIR FILTER DOWN.

PAD CHANGING INSTRUCTIONS

BETCO, CORP. 7/26/07 Page 12 PROPANE BURNISHER

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 22 23

Brak uwag

BETCO PB24-11 Instrukcja Operatora Strona 12